Flying Scotsman
I wasn't really sure what to do next as I fancied a less stressful job for a few days but since I've got back into the 'cylinder mode' I thought that I would take the first steps in dealing with the outside cylinders. I
Flying Scotsman
Next on the list was the cylinder cover for the main bore, I had machined a slightly oversized cover some months back when last working on the cylinder where you may recall I added a spigot on the back. The first job was to machine a flat on one side
Flying Scotsman
Back with the middle cylinder then, I took my time setting this up on the lathe's cross slide. After bolting the angled wedge to the cross slide and checking it was square I set the height using two centres as a guide. The picture shows the cylinder bolted
Flying Scotsman
My first thought for today was to fit the leading coupled axle so that I could turn the chassis over but realised that in doing so I wouldn't later be able to fit the brake shaft and cylinders so I inadvertently found my next job, the brake shaft,
Flying Scotsman
Return Crank: Lots of pictures for this job. First up to show what's actually being made, this is Don's drawing which more or less follows full size, in fact, the only thing that may be different is the width of the slot which looks a little
Flying Scotsman
Last time I laid out my plans on what to do next, one of the jobs on the list was to radius the axlebox slots and that's what I have made a start on today, hopefully I'll get all 6 boxes machined by the weekend. First
Flying Scotsman
Spring Hangers, or in fact machined bolts, simple enough but there's twelve of them. Specs are 1/4 Hex head, a plain shank of 5/32 x 1" long and a thread of 5/32 x 40 at 11/32 length. First, the shank including threaded section
Flying Scotsman
Next on the list is the spring gear for the main drivers . I think I have most of what's required, I bought the spring steel some time ago and since it mainly consists of small components there's a good chance that I have what I need,
Flying Scotsman
NB: There's not that much work from me on these very important parts as the expansion links were water cut and if you recall the weighshaft was CnC'd by my son for me, I still needed to assemblem them and make them look prototypical which is
Flying Scotsman
Well tonight see's 4472 with the first bit of colour, yes I managed to get paint on the inner frames. It's a little warm for enamel's really but I left it till late afternoon and got the paint on. Before that I needed to
Flying Scotsman
Continuing with the painting, deciding to paint now was not really my first choice, this decision has been made for me in a way as yesterday I was kindly asked to attend this years Bob Todd LNER memorial day, some of you probably know of this and may attend. This
Flying Scotsman
Nb: There was a lot of editing for these updates so please forgive me if they aren't totally clear So I now look at the painting and a few other parts, in preparation I have removed the smokebox, running boards, cab and front buffers. I have cut all