NLSME event Brean visit August 2021
A few pictures of the model at this annual club event
Read more
Reverser dial gauge completion.
With the cleading nearing completion I felt confident enough to finish off the reverser dial gauge and its track which in part is connected or, in my case, leaning to said cleading. When saying 'track' I am referring to the link between the reverser itself and the gauge.
Reach Rod part 3
Last time we built the the front section of the reach rod, this time we shall tackle the rear section and the two pins required for fitting of said reach rod. There's no 'fork' to worry about this time and one might think that this would
Reach Rod part 2
Last time I said that I needed to look into the reach rod joint as Don's drawing wasn't very clear and as it turned out, not to the works drawing although in his defence it would look like it was from the side which is mostly
Reach Rod Part 1
With the reverser nearing completion it was time to take a look at the reach rod, but before doing so, I decided it would be wise to do some checks on the reverser's position, make sure it was correct as the length of the reach rod is very